AR-M160/AR-EB7 SCANNER DRIVER

admin

Check the copy lamp light quantity SIM and lighting. A3 or WLT depends on the destination. See the user program “Memory allocated to printer mode”. Pentium is a registered trademark of Intel Corporation. Details of trouble codes.

Uploader: Dozuru
Date Added: 3 September 2011
File Size: 10.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7399
Price: Free* [*Free Regsitration Required]

If scanneg is not fixed, the operations cannot be guaranteed. Caution, risk of danger: Note Affix the paper size label for the paper size selected in step 3 to the label position on the right end of the tray. Page 48 USB 2. USB joint maintenance program installation The driver is installed by plug and play. SIM Machine Not stop. The correction value is stored. Insert the spring pin so that the waveform A of the spring pin faces in the longitudinal direction of the paper exit drive gear long hole B.

When the CA key is pressed, the simulation is terminated. As a part of our policy of production units Manual transport clutch E.

Drivers >>> AR-M160/AR-EB7 Scanner driver

Troubleshooting If you experience difficulty using the machine, check the following troubleshooting guide before calling for service. When the interruption key is pressed, the process is interrupted and the screen returns to the sub code entering display.

  CREATIVE LAB SB0680 DRIVER

When this simulation is executed, the currently set code number is displayed. When the [Interrupt] key is pressed at that time, the machine goes into the sub code input ar-m1600/ar-eb7 mode without rewriting the data. L8 01 Content No full wave signal Detail The zero cross signal is not detected.

After completion of the process, the machine goes into the sub code input standby mode. If you wish to select the exposure level yourself, follow the steps below. If necessary, perform the following adjustment procedure. In advance to this adjustment, the sub scanning ar-m160/ar-eb77 ratio adjustment must be performed.

If the machine is moved from a cool place to a warm place, condensation may form inside the machine.

SHARP AR-M drivers

If the rear side rail is used for the adjustment, the scanning position of the white balance sheet is shifted and “E” may occur only when scanning with the SPF. In RSPF adjustment, after the machine enters the copy mode of one page, select the single copy mode with the sr-m160/ar-eb7 key to shift to the single copy mode, making two pages of single copy.

  ADAPTEC AUA 1420 DRIVER

When a ar-m160/ar-ebb7 is pressed once, it is not counted again. Problem Paper size for a paper tray cannot be set.

Comments to this Manuals Your Name. Intermittent frame unit Assembly: Direct Download Success Stats: Put the fusing harness A on the heater lamp B as shown in the figure and fix them together. Be sure to use a USB cable for connection.

Service Manual SHARP AR -M160_M205_M206_M207 SME

The fusing unit is not installed. In “Auditing mode”, the display shows “- – -“, and this indicates that a 3-digit account number must be entered in order to use the machine for copying.

During this scanning, the set magnification ratio is displayed. After the download data transmission has been completed, exit the software program. Check the thermistor and its harness. The life cycle information is other than “Not used FFh.