LANIER LP145N DRIVER DOWNLOAD

admin

To avoid injury and prevent damage to the machine, be sure to read this. There is a lip cut into the center of the front end of the hard disk drive’s casing. Page 84 Loading Paper After loading, make sure that on either side, the paper does not catch on 1. Page 51 Installing Options Tighten the two screws to secure the Gigabit ethernet board. Tighten the two screws to secure the interface board. Paper and Other Media While pressing the release lever, adjust the side fences.

Uploader: Mikatilar
Date Added: 10 November 2016
File Size: 42.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61133
Price: Free* [*Free Regsitration Required]

For the specifications of each option, see p.

Lanier lpn Manuals

It comes off when work. AQVS Remove misfed paper slowly. The vertical adjustment is used for all trays. AQVS Attach the antenna to the card with the label facing down and the uneven side of the antenna facing up.

Printer: Lanier LPn/SP DN | OpenPrinting – The Linux Foundation

Attach the paper feed unit to the bottom of the printer. To avoid injury and prevent damage to the machine, be sure to read this. Page 84 Loading Paper After loading, make sure that on either side, the paper does not catch on 1.

Adding Staples Hold both sides of the cartridge, and then pull up the upper unit of it. AETS With the antenna and the indented end toward you, slowly insert the inter- face card until it stops. AQVS Remove the screw by turning it counterclockwise using the provided screwdriver, and then remove the cover of the Gigabit ethernet board slot. Page 22 Attaching Paper Feed Unit PB Confirm that the printer is turned off, and the power cord is unplugged from the wall outlet.

  ALC650 WINDOWS XP DRIVER DOWNLOAD

Removing Misfed Paper Open the lower vertical paper feed cover. AQVS Place the controller board on a flat surface.

AQVS Confirm the top of the stack is not higher than the limit mark inside the tray. Follow these steps to lanjer the staple refill with a new one. When a message indicating a paper size performed with PDF Direct appears, either place the indicated size in the paper tray, or Print.

Read this manual carefully before you use this machine and keep it handy for future reference. You can set the vertical value in the following range: Page 86 Loading Paper Load paper with the print side llp145n by pressing the side of the stack to the wall.

Lanier lp145n Manuals

Attaching Printer Hard Disk Drive Type Connect the blue end of the flat cable to the socket on the controller board. Removing Misfed Paper Turn the blue knob A1 downwards. Page Troubleshooting Pull up the cartridge’s knob.

  M RBQ124 DRIVER DOWNLOAD

AQVS Shake the new toner cartridge back and forth about 5 – 6 times as shown. Be sure to read these notes. Guide to the Printer Exterior: Close the l145n cover.

Tighten the two screws to secure the interface board.

AQVS Pull out the ribbon. Set the paper size using the control panel. Page 39 Installing Options Remove the screws as shown by turning laniet counterclockwise using the provided screwdriver.

Attaching Gigabit Ethernet Board Disconnect the cables from the ethernet port and the USB port of the print- er, and cover each port with its protective cap.

If the cord is unplugged abruptly, it could become damaged.

Loading Paper Load paper with the print side down by pressing the side of lznier stack to the wall. If this happens, the position of the punch waste box indicated by the arrow as shown may be blocked by punch waste.